How To Apply

Applying a vinyl decal may seem like a daunting task, but with the right technique, it can be a smooth and easy process. Follow these expert tips to ensure a flawless application every time.

Prepare the Surface

Start by cleaning the surface where you plan to apply the vinyl decal. Use a mild detergent to remove any dirt, grease, or residue. Make sure the surface is completely dry before proceeding.

Position the Decal

Place the vinyl decal on the surface without removing the backing paper. Adjust the position until you are satisfied with the placement. You can use masking tape to hold the decal in place if needed.

Peel Off the Backing

Once you are happy with the position of the decal, carefully peel off the backing paper from the decal. Take your time to avoid any wrinkles or creases in the vinyl.

Apply the Decal

Starting from one side, slowly press the decal onto the surface using a squeegee or a credit card. Work your way across the decal, applying even pressure to ensure a smooth application. Make sure to eliminate any air bubbles as you go.

Remove the Transfer Tape

Once the decal is securely applied to the surface, gently peel off the transfer tape. Peel it back at a sharp angle to prevent the decal from lifting. Take your time to ensure the vinyl stays in place.

Smooth Out Any Bubbles

If you notice any air bubbles under the decal, use a pin or needle to puncture the bubble carefully. Then, press the vinyl down to release the air and smooth out the surface.

Let it Set

Allow the vinyl decal to set and adhere to the surface for at least 24 hours before exposing it to any extreme conditions, such as water or heat. This will ensure a long-lasting application.

By following these steps and taking your time, you can achieve a professional-looking finish when applying a vinyl decal. Remember, practice makes perfect, so don't be discouraged if your first attempt isn't flawless. With a bit of patience and precision, you'll be a vinyl decal application expert in no time!